Chained triggers

@nitrogenwidget wrote:

Thank you for taking the time to submit your bug/issue! Please use the points below as a guide when submitting.

• Device & model you are using (Ex: Pi 2 Model B or Arduino Uno with W5100 ethernet shield)

RPI 2

• What dashboard are you using? (Web, iOS, Android)
  web and android

• Please describe the bug / issue as detailed as possible. Attaching the code and any relevant screenshots would be very helpful!

I have a trigger to turn on the heater for my hot tub at a certain temperature.
I also have a trigger to turn on the pump when the heater comes on.
The heater relay triggered but the pump did not.

I hooked everything up last night and it's been triggering fine all day.
Then I noticed a hiccup just now while monitoring it.

Is there a better way to minimize misfires like this?
If I just create two triggers, one for the heat & one for the pump to turn on & off at the same temp would that be better?

Also, there is a pressure switch on the heater so it won't start until the pump is running so there is no danger of bad things happening other than my hot tub getting cold.

Thanks.

Posts: 1

Participants: 1

Read full topic